Preview

Isolation of Rna

Good Essays
Open Document
Open Document
298 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Isolation of Rna
Isolation of yeast RNA

Methods

The experiment was first started through mixing of 3.0 g dry yeast, 5.0 ml of 1% NaOH and 25.0 ml distilled water in 100 ml beaker. The resulting mixture was heated in a boiling water bath for 15 minutes while being stirred. The suspension was strained using cheesecloth and the obtained filtrate was obtained and collected in the beaker. This was then centrifuged at maximum speed for about 10-15 minutes. Centrifugation, which uses the idea of gravity, break up the cells and leads to the sedimentation of the largest particles present, the nuclei. Increasing the centrifugal speed brings about the sedimentation of first the cytoplasmic large and small granules. RNA was obtained from the cytoplasmic fractions.

After centrifugation, the supernatant was collected while the residue was discarded. Glacial acetic acid was added in the supernatant until it became slightly acidic. The obtained solution was again centrifuged and filtered through the cheesecloth. Centrifugation and filtration was performed many time until the supernatant became clear.
The supernatant, was placed in a boiling water bath on which it is evaporated to approximately 5 ml. The 5 ml mixture was cooled to 40oC and 10 ml acidified 95% ethanol was included with vigorous stirring.

The resulting mixture was placed in an ice bath for at least thirty minutes. This was again centrifuged for 5 minutes at 6000 rpm and the supernatant was discarded. The formed residue was washed with 1ml of 95% ethanol and twice with a small amount of water. The washed crude RNA was transferred in an evaporating dish and was quantitatively determined for its weight. This stock RNA was then added with 0.14 M Tris-HCl buffer to form 10 ml of 10%(w/v) stock RNA

You May Also Find These Documents Helpful

  • Good Essays

    Experiment 13B

    • 972 Words
    • 4 Pages

    A reflux condenser was assembled using a 25-mL round-bottom flask, hot plate, and aluminum block. It was equipped with a drying tube filled with calcium chloride to control vapors. Approximately 2.5 mL of isopentyl alcohol was massed and placed in the round-bottom flask that contained a stir bar. Using the same graduated cylinder, about 3.5 mL of glacial acetic acid was added to the flask. A calibrated Pasteur pipet was used to add 0.5 mL of concentrated sulfuric acid to the flask and the flask was mixed immediately. The flask was connected to the apparatus and covered with aluminum foil to help retain heat. Using rubber tubing, water was circulated into the lower attachment and out the top attachment and the mixture was brought to a boil. After heating under reflux for 60-75 minutes, the flask was removed from the heating source and left to cool down to room temperature. The reaction mixture from the flask was transferred to a culture tube and 5-mL of water was added. Upon addition of water, careful shaking, and occasional venting, the phases separated and the lower aqueous layer was removed and discarded. Using the same procedure as explained above with water, 2.5 mL of aqueous sodium bicarbonate was added and the lower aqueous layer was again removed and discarded. The same procedure was repeated one last time with 2.5 mL of saturated aqueous sodium chloride and the lower aqueous layer was removed and discarded, leaving behind the crude ester. The crude ester was transferred to…

    • 972 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Oil Of Wintergreen

    • 516 Words
    • 3 Pages

    The solution then gets foggy/cloudy and white snowlike precipitate is floating within the solution. Heat is added along with a stir bar. The stir bar starts stirring at minute 7. It begins to dissolve the white powder as it spins. At minute 26 the solution becomes clear with barely any flakes left. Sulfuric acid is then added and white flakes are formed. More acid is added until the pH paper turns red. The round bottom is filled with white precipitate. The precipitate is put onto a hirsh funnel that uses vacuum filtration to isolate the precipitate. The product is then added to a beaker with D.I water and heated. It’s put through the hirsh funnel . 3.68 grams of salicylic acid is recovered. The melting point is tested to compare to a perfect sample. The melting point is 146C0. The product is dried and added to a beaker with D.I. water and 10mL of acetic anhydride and 20 drops of concentrated sulfuric acid. This product is chilled to produce crystals. Its then filtered using a hirsh filter using vacuum filtration. Recrystallized and filtered one last time. The product is now acetylsalicylic acid…

    • 516 Words
    • 3 Pages
    Good Essays
  • Good Essays

    10 drops of an unknown solution into a test tube. add four drops of 6M HCl, then stir it and place in centrifuge for 30seconds to a minute. Test for completeness of precipitation after testing for precipitation add one drop no more than one drop of 6 M HCl to the supernate. When the supernate turns cloudy means a few of the group 1 cations have precipitated. Add few more drops of the 6 M HCl, stir, then centrifuge. If necessary repeat the process until no more precipitate forms. take the precipitate and add 5 drops of water.…

    • 1128 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Micro centrifuge separate protein from DNA .Isopropyl alcohol allows DNA to be visible without any assistance mechanisms .Resuspension buffers are mixed with lysis and isolate DNA .Ethanol precipitates nucleic acids out of solution. Sample tubes are used to hold the samples.…

    • 509 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Lab 8 Isopentyl acetate 1

    • 599 Words
    • 3 Pages

    Assemble a reflux apparatus (Figure 4) with a 50 mL round bottom flask with a heating mantle. Add 5 mL of isopentyl alcohol and 7 mL of acetic acid to the round bottom flask. While stirring add 1 mL of acetic acid to the round bottom flask. The solution was gently heated until the solution was boiling and then refluxed for 60 minutes. The solution was then transferred to a separatory funnel. 10 mL of DI water was added to the funnel. Then the funnel was carefully shaken and vented to allow gasses to escape. The solution was then allowed to rest for two minutes. After resting the bottom aqueous layer was drained rom the funnel. The water wash process was repeated again. Then the organic layer was washed with 5 mL of 5% sodium…

    • 599 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    The aim of the experiment was to test for the presence of DNA, RNA, protein and glycogen in the cytoplasm and the nucleus of bovine liver cells. From the findings of the results the distribution of these macromolecules can be shown within the liver cell. This was carried out by undertaking qualitative experiments, where the observation of a colour change was noted and a quantitative experiment, where numerical data was recorded from the measurements of light absorbance.…

    • 3513 Words
    • 15 Pages
    Powerful Essays
  • Good Essays

    Through the top of the condenser, 14 mL of concentrated sulfuric acid was added drop wise over a period of ten minutes. The addition of the acid created a change in color of the solution to a rustic orange color. The mixture was refluxed for 30 minutes and the solution changed to a faded yellow-orange color. Once reflux was complete, a simple distillation was set up, with the 25 mL collection graduated cylinder placed in an ice bath. The mixture was distilled and combined with the hood partners’ distilled mixture. The distillate was placed in a separatory funnel with 10 mL of distilled water. Once separated, the distillate was added to the funnel again with 9 M sulfuric acid. The organic layer was still in the funnel after separation, as distilled water was added to the solution and then 10 mL of a saturated solution of sodium bicarbonate. The organic solution was dried with anhydrous sodium sulfate for a week. The liquid product was transferred to a 25 mL round bottom flask equipped with a stir bar and a simple distillation was set up. The solution was distilled and the density of the bromide was calculated at 1.222 grams/mL with a boiling range of 87-92◦C. The theoretical yield was calculated at 12.847 grams and the percent yield was 72.3 percent. Next was the characterization and assessment of the purity of the…

    • 1325 Words
    • 6 Pages
    Good Essays
  • Satisfactory Essays

    Rna Primase

    • 206 Words
    • 1 Page

    DNA primase is an enzyme involved in the copping of DNA and is a type of RNA polymerase. Primase speed up the synthesis of a short RNA (or DNA in some organisms [1]) a part called a primer complementary to a ssDNA template. Primase is of key importance in DNA replication because no known replicative DNA polymerases can begin the synthesis of a DNA strand without an initial RNA or DNA primer. After this elongation, the RNA piece is removed by a 5' to 3' exonuclease and refilled with DNA. primase uses a phosphotransfer domain for the transfer coordination of metals, which makes it distinct from other polymerases. The side subunits include a NH2 and COOH terminal made of alpha helixes and beta sheets. The NH2 terminal reacts with a zinc binding…

    • 206 Words
    • 1 Page
    Satisfactory Essays
  • Powerful Essays

    P. 258 Rrna Analysis

    • 1135 Words
    • 5 Pages

    RNA is like an enzyme when it is a catalyst and helps assist in the reduction of the activation energy which relates to tRNA when it attaches its amino acid to the rightful place. This helps construe a faster translation.…

    • 1135 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    The purpose of this lab was to evaluate our skills of decanting a supernatant liquid without losing the solid and successful completion of a series of reactions. This was done through five chemical reactions involving copper. In this lab, elemental copper was put through five different chemical reactions in order to convert it into different compounds. By the end of the fifth reaction, the copper was back to its elemental state.…

    • 842 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Rna Synthesis Essay

    • 171 Words
    • 1 Page

    You could get over amplification of your DNA due to genomic DNA contamination. This would affect your reaction because you will get false results due to that over amplification.…

    • 171 Words
    • 1 Page
    Satisfactory Essays
  • Satisfactory Essays

    anthropology DNA RNA

    • 254 Words
    • 2 Pages

    2) DNA has Adenine, Guanine, Thiame, and Cytosine as nitro bases. With RNA, anywhere you would…

    • 254 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    benzoate was added, the cold nitric acid/sulfuric acid mixture was added to the conical vial…

    • 768 Words
    • 3 Pages
    Good Essays
  • Good Essays

    CHEM 2070 LAB

    • 604 Words
    • 3 Pages

    After trying to decant the solution, and attempting to keep the precipitate in the beaker, which was difficult to do as some of the precipitate left the solution along with the hot supernatant liquid in the heated solution, 20 mL of distilled water was added to the precipitate.…

    • 604 Words
    • 3 Pages
    Good Essays
  • Better Essays

    5. Biological Centrifugation (Spin biological), by D. Rickwood, J.M. Graham (2001). [Online]. Available at: http://www.coleparmer.com/TechLibraryArticle/910…

    • 1541 Words
    • 7 Pages
    Better Essays