Preview

Dehydration of an Alcohol lab report

Powerful Essays
Open Document
Open Document
1201 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Dehydration of an Alcohol lab report
Experiment 9-Dehydration of 2-methylcyclohexanol
Name______________________________________________________________________
Lab Partner_________________________________________________________________
Lab Day and Time____________________________________________________________
Report appearance
(Typed, on time, in order, presentable, complete)

1
2
3
4
5

Abstract

1
2
3
4
5

Introduction

1
2
3
4
5

Reaction Scheme and Curly arrow mechanism

2
4
6
8
10

Table

1
2
3
4
5

Experimental Procedure

1
2
3
4
5

Calculation (percentage yield and composition of isolated materials)
1
2
3
4
5

Results and Discussion (include GC)
1
2
3
4
5

Completion/participation of the Experiment
1
2
3
4
5

Total
Comments

/50

Lab 9 Report Template: Acid Catalyzed Dehydration of 2-Methylcyclohexanol
Abstract
In Experiment 9, distillation was used to carry out the dehydration of 2-methylcyclohexanol using 4:1 mixture of phosphoric and sulfuric acid. Gas Chromatography was then used to measure the products. Two products were formed. The theoretical yield of the alkene mixture was 3.914 g. The actual yield of the mixture was 0.73 g. The percent yield for the reaction was 18.65%. Peak A had an area of 0.3 mm2 and a percentage of 4.6 %. Peak B had an area of 6.21 mm2 and a percentage of 95.39%.
Introduction
The acid used speeds up the dehydration of the alcohols. This is an elimination reaction. Water is eliminated from the reaction and the products formed are alkenes. The reaction follows Zaitsev’s rule because it is an elimination reaction. Zaitsev’s rule says that the double bond that is more highly substituted or more stable will be dominant in the products. In the experiment the dehydration of 2-methylcyclohexanol takes place. 2 methyl-cyclohexanol has a very poor

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Orgo Lab 5

    • 539 Words
    • 3 Pages

    The objective of this experiment was to carry out an elimination reaction on 2-methylalcohol with an acid to produce alkenes as a product. The product formed is separated through distillation. Because more than one alkene product can result from the reaction, Gas Chromatography is used to analyze the composition of the product mixture. IR spectrometry is also carried out to confirm the product.…

    • 539 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    When the product is formed, you want it to follow Zaitsev’s Rule. When the more stable product of an elimination reaction predominates the reaction is said to obey Zaitsev’s Rule. An E1 m reaction will obey Zaisev’s Rule. In this experiment two forms of alkenes are produced, disubstituted and trisubstituted alkene is more stable than the disubstituted. The di- and tri- are very important to understand. They refer to double bond and how it is attached to whatever number…

    • 774 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    The basic purpose of this experiment is to carry out the dehydration of an alcohol and isolate the reaction products by distillation. Gas Chromatography will be utilized to analyze the reaction mixture.…

    • 896 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    O Chem

    • 729 Words
    • 3 Pages

    40ml of an equimolar mixture of cyclohexane and toluene was obtained and transferred into a 100ml round bottomed boiling flask which contained boiling chips. The distilling column was packed with metal sponge and the height was measured in centimeters and recorded. The distillation apparatus was assembled and a heat mantle was set. Several vials were used as fraction receivers. The vials were labeled, 1-4, and weighed prior to adding the liquid mixture and after the liquid was added. The temperature was recorded before adding heat in order to begin distillation (20º C). The temperature was recorded prior to each distillation fraction and after each 2ml of distillate which was recorded in table 1. The system was turned off and cooled down letting the remaining condensed vapor drain into the round bottomed flask. This sample was transferred by pipette into a vial…

    • 729 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Gas Chromatography Lab

    • 648 Words
    • 3 Pages

    E1 reactions are two-step unimolecular reactions. The first step of an E1 reaction occurs when a leaving group, which consists of a weak base, leaves an organic compound, leaving an intermediate carbocation. In the second step, a carbon on the organic compound is deprotonated by a Lewis base, resulting in the formation of an alkene. The dehydration reactions of 1- and 2-Butanol with sulfuric acid occur through an E1 mechanism, so they follow the steps previously…

    • 648 Words
    • 3 Pages
    Satisfactory Essays
  • Better Essays

    Perhaps you have heard the phrase “water is life”. When it comes to the human body, nothing could be more accurate. The system of fluids in the body that water affects controls everything from nerve impulse to movement; it is even part of the very structure of our bodies. The following will discuss the vital connection between different systems in the body and how they use water to maintain proper health and function. We will discuss what happens to the body when we intake too much water (water toxicity), likewise when we lose or intake too little (dehydration).…

    • 1705 Words
    • 7 Pages
    Better Essays
  • Satisfactory Essays

    The purpose of dehydrating 2-methylcyclohexanol is to understand elimination reactions. It is also necessary to utilize organic chemistry techniques, such as distillation, and analyze infrared and gas chromatography spectrums. Dehydration of 2-methylcyclohexanol occurs via an E1 mechanism, in which the major product is the most stabilized alkene. In this experiment, the product obtained was methylcyclohexene. This product was successfully tested for unsaturated and achieved a percent yield of 93%. Due to this high yield, this was a rewarding experiment - the alkene, methylcyclohexene, was successfully achieved and without large amounts of impurities as well. With more practice and understanding of elimination reactions, dehydrating compounds…

    • 110 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Decarboxylative Mechanism

    • 590 Words
    • 3 Pages

    III. Conclusion: In this experiment, 2-methylcyclohexanol was mixed with phosphoric acid with heat, to produce 3 isomers in one solution. This solution was run through a GC to calculate the product distribution. One isomer was such a rarity that it did not register on the GC. 1-methylcyclohexene accounted for 82.9% of the product solution. 17.1% was the 2-methylcyclohexene products.…

    • 590 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Dehydration Lab Report

    • 1056 Words
    • 5 Pages

    Then elimination can occur both sides to form three products. The composition of three components between two reaction of dehydration of primary and secondary alcohol is different because of placing OH group to different…

    • 1056 Words
    • 5 Pages
    Satisfactory Essays
  • Satisfactory Essays

    3. Briefly compare and contrast the effectiveness of simple and fractional distillations in the separation of a solution of…

    • 397 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    In the first step, the mixture of water, concentrated sulphuric acid, and cyclohexene was shaken vigorously until it became a homogenous solution. Followed by, the addition of water, and the distillation process lead to the hydrolysis of the alkene. Finally, addition of diethyl ether to the mixture then distillation took place to be purified and to obtain the final product, cyclohexanol (McFadden, 2012). Diethyl ether was used to extract alcohol from salt-water mixture because diethyl ethers solubility in water is lower than cyclohexanol which helps remove alcohol from the salt-water mixture (Merzougui, A, et al., 2011).…

    • 2173 Words
    • 9 Pages
    Better Essays
  • Powerful Essays

    “This cyclohexene from cyclohexanol reaction belongs to a broad class of organic transformations called elimination reactions, and within that class, this E1 elimination reaction constitutes another of the cornerstone reactions of organic chemistry. Mechanistically related to the SN1 reaction, the E1 often competes with attempted substitution.” (5) Through proper choice of reaction conditions, it can usually be made the predominant or exclusive pathway. For example, one of the principal ways to prepare alkenes is via the acid catalyzed dehydration of an alcohol…

    • 2363 Words
    • 10 Pages
    Powerful Essays
  • Good Essays

    Dehydration Lab Report

    • 821 Words
    • 4 Pages

    This experiment was done to demonstrate the practical use of dehydration reactions and produce three different products. Dehydration reactions are reactions that involve the leaving of an “-OH” or “-H” group resulting in the formation of a double bond between two carbons. For the experiment we used 2-Methylcyclohexanol as a beginning reagent to dehydrate and possibly form 3-methylcyclohexene, 1-methylcyclohexene, or methylenecyclohexane. Drierite® (Calcium Sulfate) was used as a drying agent to help break the alcohol and hydrogen groups from the carbons. Concentrated phosphoric acid was used as a catalyst to help move the reaction towards the products motioned above. To determine the successfulness of the experiment and the amount of product(s) recovered, IR spectroscopy, Gas Chromatography and percent yield calculations were used.…

    • 821 Words
    • 4 Pages
    Good Essays
  • Good Essays

    References: [1] Crismyre, Bobby, Do, Bryan, and Kronmiller, Mandy. “Ethyl Acetate – NaOH Reaction Kinetics Experiment Standard Operating Procedures,” (2010) [2] Julio F. Mata-Segreda, Hydroxide as a General Base in the Saponification of Ethyl Acetate.…

    • 3367 Words
    • 14 Pages
    Good Essays
  • Powerful Essays

    acetone

    • 9648 Words
    • 49 Pages

    Acetone is a clear, colorless, volatile liquid with sweer odor. It is both the simples aliphatic ketone and the most commercially important. It has a distinctive fruity or mint-like odor and a pungent taste. It is also found naturally in plants, tress, volcanic gases, and forest fires and as a by product of the breakdown of body fat. Nearly all world production of acetone is via cumene peroxidation, as a coproduct with phenol. Its main use is as a chemical intermediate in the manufacture of acetone cyanohydrin for methyl methacrylate, bisphenol A and aldol chemicals. Catalytic dehydrogenation of propanol can be chosen as an alternative synthetic route when high-purity of acetone is required, such as in biomedical applications. A single pass conversion of 85-92% wuth respect to isopropanol, with reactor conditions of 2bar and 350oC, is generally achieved for this process (Turton et. al, n.d as in Tremoulet, Unton, & Feng, 1998). A molten salt will be used a heat source for the endothermic reaction:…

    • 9648 Words
    • 49 Pages
    Powerful Essays